all kinds of spare parts!

[brooksgnm]

I've always got lots of miscellaneous spare fox body parts at the house. If anybody ever needs something little to complete their car, I probably have it. Off the top of my head the things I have right now are: Roof section w/ sunroof from 87gt, rear half of a hatchback w/ near perfect california quarters, bubbleback hatch from capri, a couple gas tanks, lots of factory suspension/steering/brake pieces, some perfect rear quarter glass (87-93), lots of late model interior pieces, another sunroof glass, some misc. wiring harnesses, a couple GT wings, a couple 5spd pedal assys, misc. exterior trim, and theres more where that came from let me tell you! Feel free to drop me a line if you need something to complete your car. Thanks Dayton 5.0! -Mark

[whitestang88]

Thank God!!! I need a front fender skirt, the one that connects the fender to the bumper cover for the passenger side for a 88 gt and I also need a 140 speedo cluster, some good looking pony wheels and a mass air computer for a automatic. Any help is greatly appreciated, I have been looking for these parts for quite a while with no luck. I need all of these for an 88 gt also I will probably need the mass air wiring harness if it is the same for a mass air conversion.

Thanks for any help

[chappys50]

every stang i've got has been an aod, every1 has failed, just put a rebuild unit in last year..have told myself that if this one does that i will hang a clutch pedal..what is involved in this procedure???

got any good lower steering shafts???

87-89 horn pad???

ford has discontinued these items, go figure...

[chappys50]

i have a 80 cobra that i am wanting to put ground effects on it, it has a 80 cobra nose that is very similar to a 85 gt..what i want to do is go all the way around the car...

working on this project, long time in progress...

working on both the body & drivetrain, removed 4.2L for a mild 5.0L, couple of weeks after i installed the engine, lost the front trans seal, yanked tranny, reworked & sealed, aint ran since. house & 1 child later, it seems like never enough time or $$$ anymore. but the last couple of months the weather has gotten to me, bent the trans cooler lines the other night, hope to have this one to the track late this year, should run high 12's...would like to get the body done before i take it out...

let me know if u have anything that i can get from u...

[brooksgnm]

chappys50, I envy you, the early fox cobras are one of my favorites! putting in a clutch pedal assembly isn't too hard, I've swapped out a few and pulled a few more... basically you want to pull the drivers seat, then the column, then swap it out. It's a fair bit of work, and your back will hurt the next day, but any mechanically inclined person can easily do it. I've got a few lower steering shafts. I do have an 86 cruise wheel, not sure if that would have the right horn pad?? I assume you want to put 87-93 GT mouldings on it? If so, sorry I sold a complete set I had over the winter, now I just have one piece from another car. If you'd like to come out and see what I've got feel free to drop me a line at brooksgnm@hotmail.com.
whitestang88, I pm'd you with some info, in case you haven't checked it out yet.

[BenBram]

Got any A9L's?

Thanks,

-Ben

[brooksgnm]

Ben, I had one just last week, and it's already in my cousin's car.. I haven't been into the computer stuff much until just recently, but now after driving a 5.0 with a computer I see why people like them so much! They're soooo much easier to drive, and have a very different feel, like they're more refined. I looked on ebay yesterday and it looks like there's a steady stream of A9L's on there. Try auction #2420843044 or 2420956211 or 2421104565 or 2421128057 those are the ones that looked like real original A9L's. -Mark